Yamaha R1 Service Manual for the and R1. Click the following link to view the manual: Yamaha R1 Service Manual This – Yamaha R1 Owner’s Manual LITIn “Manuals”. View and Download YAMAHA YZF-R1 owner’s manual online. YZF-R1 Motorcycle pdf manual download. View Yamaha Owner’s Manuals Online. The Yamaha Owner’s Manual Section offers the ability to view Owner’s Manuals for many past Yamaha models. Step 1.
|Published (Last):||22 August 2013|
|PDF File Size:||2.23 Mb|
|ePub File Size:||9.31 Mb|
|Price:||Free* [*Free Regsitration Required]|
EAU Welcome to the Yamaha world of motorcycling! This manual should be considered a permanent part of this motorcycle and should remain with it even if the motorcycle is subsequently sold.
Yamaha continually seeks advancements in product design and quality.
Therefore, while this manual contains the most current product information available at the time of printing, there may be minor discrepancies between your motorcycle and this manual. Any reprinting or unauthorized use without the written permission of Yamaha Motor Co.
However, they also impose certain limits, which you must accept; even the best motorcycle does not ignore the laws of physics. Regular care and maintenance are essential for preserving value and operating condition of your motorcycle. Fuse box page 2. Front fork compression damping force adjusting screw page 3. Front fork rebound damping force adjusting screw page 4.
Front fork spring preload adjusting bolt page 5. Front brake fluid reservoir page 6. Luggage strap holders page Air filter element page Helmet holders page Radiator cap page Main fuse page Coolant reservoir page Electronic fuel injection fuse page Clutch lever page 5. Tachometer page 2. Left handlebar switches page 6. Right handlebar switches page 3.
Multi-function display page 7. Throttle grip page 4. When this oc- This warning light comes on when the curs, have a Yamaha dealer check the engine oil level is low. The electrical circuit of the warning light If the warning light does not come EAU on for a few seconds, then go off, Engine speed indicator light have a Yamaha dealer check the The electrical circuit of the indicator electrical circuit. Go ahead with riding. Stop the motorcycle and allow it to idle until the coolant temperature goes down.
If the multi-function display indicates 1. Engine speed indicator light activi- NOTE: To make any settings in this mode, ty: This function allows you to you have to cycle through all of its choose whether or not the indica- functions. Contact a Yamaha dealer for more information. Tachometer red zone 2. To signal a left-hand with the starter. Arrow mark Clutch lever Shift pedal a.
Distance between brake lever and handlebar The clutch lever is located at the left The shift pedal is located on the left grip handlebar grip. The fuel tank cap cannot be closed un- less the key is in the lock.
In addition, the key cannot be removed if the cap is not properly closed and locked. If knocking or pinging. This motorcycle is equipped with a cat- Check the fuel tank breather hose alytic converter in the muffler.
Passenger seat lock 2. EAU Seats To install the rider seat Passenger seat Insert the projection on the front of the To remove the passenger seat Rider seat rider seat into the seat holder ownfrs 1. Some helmets may contact the muf- 1.
YAMAHA YZF-R1 OWNER’S MANUAL Pdf Download.
Storage compartment Always adjust both fork legs equal- 1. Rebound damping force adjusting screw 1. Compression damping force adjusting screw 2. Align the appropriate groove on the ad- force and thereby harden the rebound Compression damping force adjusting screw Rebound damping force Compression damping force To increase the rebound damping To increase the compression damping force and thereby harden the rebound force and thereby harden the compres- damping, turn the adjusting screw in di- sion damping, turn the adjusting screw Do not deform or damage the seat.
See page for passenger gas cylinder in any way, as this seat removal and installation proce- will result in poor damping per- dures.
Always have a Yamaha dealer service the shock absorber. Changing scribed below and have a Yamaha these settings without sufficient dealer repair it if it does not function technical knowledge may result properly. Periodically check the operation of the ignition circuit cut-off system according to the following procedure. Push the start switch. Does the engine start?
2003 Yamaha YZF-R1 — Owner’s Manual
The neutral switch may be defective. The motorcycle should not be ridden until checked by a Yamaha dealer. With the engine still running: Move the sidestand up. Keep the clutch lever pulled. Pre-operation checks should be made each time the motorcycle is used. yamah
Such an inspection can be accomplished in a very short time; Start the engine by pushing the If the engine fails to start, release the start switch, wait a few seconds, and Even with the transmission in then yamana again. Each starting attempt the neutral position, do not should be as short as possible to pre- mnual for long periods of time serve the battery.
Keep the engine speed out of other flammable materials. If any engine trouble should oc- cur during the engine break-in period, immediately have a Yamaha dealer check the vehi- cle.
Periodic inspection, adjustment and lu- ence required for a particular job, have brication will keep your vehicle in the a Yamaha dealer perform it for you.
The most important points of in The annual checks must be performed every year, except if a kilometer-based maintenance is performed instead. From 50, km, repeat the maintenance intervals starting from 10, km. Items marked yamwha an asterisk should be performed by a Yamaha dealer as they require special tools, data and techni- cal skills.
Cowling B EAU 3. Remove the quick fasteners at the cowlings and panels front of the cowling. Turn signal light lead coupler 1. Disconnect the turn signal light To install the quick fastener, push the 2. Since heat and deposits will cause any spark plug to slowly erode, they should be removed and checked in accordance with the periodic mainte- a. Remove the oil yamxha cartridge with and drain bolt to drain the oil from an oil filter wrench.
An oil filter wrench is available at a Skip steps 5—7 if the oil filter cartridge is Yamaha dealer. Add the specified amount of the recommended engine oil, and then install and tighten the oil filler cap.
Without oil filter cartridge replacement: Owenrs addition, the cool- minimum and maximum level marks. If the coolant is at or below the min If water has been added to gamaha necessary. Remove manuql A and B, and check the antifreeze content of panel A. See pages — for After the coolant is completely drained, iwners flush the cool- ing system with clean tap water. Install the coolant drain bolt, and then tighten it to the specified torque.
Check the washer for damage and re- place it if necessary. Start the engine, and then check the coolant will be reduced. If coolant is leaking, have a Yamaha dealer check the cooling system.
Install the cowlings and the panel. Fuel tank breather hose 1. Fuel ownegs overflow hose 2. Air filter case cover Replacing the air filter 3. Lift the front of the fuel tank, and 5.