Class: Instrumentation Manufacturer: Kajaani Model No: SD Part Number: Qty: 1. Description: Automatic Sample Valve. follow-up through a communicator or Kajaani interface via Ethernet. Three operating modes: • Manually initiated. • Collection timer 24/7. STEC SEC Mass Flow Controller. ₪. METSO KAJAANI SD TRANSMIITER USED. ₪. MKS Flow Meter (N2) – Model ALS3BV.
|Published (Last):||15 January 2011|
|PDF File Size:||16.72 Mb|
|ePub File Size:||10.61 Mb|
|Price:||Free* [*Free Regsitration Required]|
Press the new O-ring into the bearing bush.
Email to friends Share on Facebook – opens in a new window or tab Share on Twitter – opens in a new window or tab Share on Pinterest – opens in a new window or tab.
The sampling devices are installed to the process pipeline, and they extract pulp samples from the process. Please enter 5 dd5002 9 sd502 for the ZIP Code. This amount is subject to change until you make payment.
Replacing the pressure switch Remove the old O-ring part 16 from the bottom of the bearing bush. The device may have been in contact with toxic or otherwise hazardous substances.
מדי זרימה נוזלי והמונית: פשוט לקנות באיביי בעברית – זיפי
Hex nut M4 acid-proof DIN Pressure switch Unfollow kajaani to stop getting updates on your eBay Feed. Kappa sample, blow-off Raw water Temperature Drive in the seal ring using a hammer and the installation tool. Positioning the flow inlet opening Take the seal ring and installation tool from the freezer. Made of Titan; otherwise similar to SD End clamp EW 35 Be the first to write a review.
Then pull the bush out of its casing by turning nut A. Sign in to check out Check out as guest. Slotted cheese-head screw M3x8 acid-proof DIN Fasten the sampling device to the process coupling with a clamp.
Kajaani SD-502 Automatic Sample Valve
Tighten nut 20 properly — make sure that the connection does not move sideways se5002 tightening it! Sample line connectors to the analyzer. Make sure that the support ring part 22 is wound as far as it goes. Devices can also be sent to the manufacturer for recycling and disposal. Make sure that PVC components are disposed of as specified by local regulations.
Kajaani SD Automatic Sample Valve
Non-recyclable materials Non-recyclable kajaani must be disposed of according to currently valid local legislation and regulations. Push the closing piston into position, and also place the kajaan guard part 19 on the shaft part When the sampler cover is open, watch out for moving parts. Mount the sampling device on a vise, in the position shown in Fig.
Metso will accept only thoroughly cleaned devices, and the cost of recycling will be invoiced from the customer; please ask for recycling quotation. Loctite on the thread that connects the piston shaft part 15 and actuator shaft. Tighten the hex socket screw properly.
Connection box, front view. Watch out for the moving parts when testing the sampling device operation — do not push your fingers between them! Maintenance kamaani 2 weeks 1. For additional information, see the Global Shipping Program terms and conditions – opens in a new window or tab This amount includes applicable customs duties, taxes, brokerage and other fees.
If these surfaces are visibly scratched and grooved, replace the piston; see point 6. Sampling device SD The SD is a flow-type sampling device for low consistencies and particularly for unscreened pulps that may contain shives or chips. Watch sd5020 is full. Pressure switch – Adjust with screwdriver, check with multimeter Fig.